Quick Answer: Which of the following is a life safety consideration for first responders and the public during a structural fire incident?

Which of the following skills is the most critically important for a firefighter?

Knowledge of building construction or fire behavior? All of these are important of course, but I would venture to say that the most important skill or attribute for a firefighter is the ability to work together with others as part of a coordinated team.

Which of the following is an essential consideration in the design of fire protection systems?

Which of the following is an essential consideration in the design of fire protection systems? … Fire resistance rating (in hours) of exterior bearing walls.

What potential fire safety hazard does an atrium pose?

The base of the atrium is especially vulnerable. Potentially, a fire at this location can fill the shaft with smoke and allow fire to spread rapidly from floor to floor. Occupants using escape routes within the atrium space during fires may not reach an exit.

Which of the following is a requirement for fire walls?

Which of the following is a requirement for fire walls? They must serve as an absolute barrier to fire and structural collapse on either side of the wall.

IT IS IMPORTANT:  Quick Answer: What is the highest paying firefighter?

What are the 7 sides of a fire?

Command must consider the seven sides (or sectors) of the fire: front, rear, both sides, top, bottom, and interior. Fires cannot be considered under control until all seven sides are addressed. Failure to address all seven sides will frequently result in fire extension.

What are the basic fire protection systems?

Fire-protection and life safety systems include building exit systems, fire-alarm systems, and fire-suppression systems. … Passive fire protection involves the use of building components to control or limit a fire. Walls, floors, and ceilings can be designed and constructed to resist the passage of fire and smoke.

What is the term for a wall framing member?

stud. one of an array of small closely spaced parallel wall framing members; heavy steel pin. rafter. a framing member that runs up and down the slope of a steep roof, is basically a joist at an angle.

What are the three techniques used to fight fires?

The following are the basic firefighting techniques that exist:

  • Direct Attack Technique. This must be the most well-known technique for firefighting. …
  • Indirect Attack Technique. …
  • The Combination Attack Technique. …
  • Fog Attack Technique. …
  • The “Two Lines In” Technique.
Tame a raging fire