Can you use an elevator after the fire alarm system has been activated?

When the Fire Alarm sounds, act immediately to ensure your safety. The Fire Alarm System is designed and engineered to provide you with an early warning to allow you to safely exit the building during an emergency situation. … Never use an elevator to exit during a fire alarm activation.

What happens to the building elevators when a fire alarm is activated?

When the fire service mode is activated, the elevator cab is designed to return to the ground floor. If smoke is detected on the ground floor, the elevator is designed to return the cab to an alternate floor. Once the cab has arrived at the recall floor, the elevator doors should open.

Do elevators stop when fire alarm?

If people are in an elevator when a Fire Alarm Initiating Device (FAID) activates, the elevator will automatically move to a safe floor, away from the fire, and shut down with the doors open. The elevator will then remain unavailable for normal use until it is reset.

How do you reset an elevator after fire alarm?

How to Reset an Elevator After a Fire Service Alarm?

  1. Locate the Phase 1 Key Switch in the hallway. With the fire service key, turn it “RESET” or “BYPASS” and hold it for about two to three seconds. ​
  2. Turn the key back to the “OFF” position. The elevators are now reset for normal use.
IT IS IMPORTANT:  What is AB type fire?

When can you use elevators in a smoke fire incident?

Although elevators are used for evacuation from other types of emergencies, only exit stairs can be used during a fire emergency. The only exception to this rule is that individuals with mobility impairments can use the elevators during a fire emergency (more information is provided in the following section).

Why can’t you use the elevator during a fire?

It isn’t appropriate to use an elevator during a fire or similar building emergency. Elevators are designed to be recalled to a floor, usually the lobby, during alarm conditions. … Also, smoke may enter the elevator shaft, which would migrate toward the roof, exposing any elevator occupants to that smoke.

What 3 items are in a fire safety plan?

This Fire Safety Plan must include:

  • the measures to be taken to minimize the likelihood of fire at the site and to control the spread of fire;
  • the emergency procedures to be followed in case of fire, including: activation of alarms, notification of the fire department, and.

What happens if you’re in an elevator during a fire?

Once the fire begins to spread, the smoke can easily flood the elevator shaft. This will suffocate anyone in the elevator at the time, and so is extremely dangerous. The movement of the elevator will act as a billows in the building, pushing air around and making it even easier for the fire to spread.

How do you reset an elevator in your home?

To reset and return the elevator to normal operation, make sure no one is in the elevator hoistway and all landing doors are tightly closed. Then, turn off the elevator’s main house power breaker (EXCEPT IN FLORIDA — SEE FLORIDA STEP BELOW).

IT IS IMPORTANT:  Do local fire departments fill pools?

How do you reset elevator communications failure?

Insert the elevator key into the call panel lock. Turn the key to the reset position. Leave the key in this position for several seconds. Turn the key back to the off position.

Tame a raging fire